Table 3. Physical specifications Table 4. Electrical specifications WARNING! Power requirements are based on the region where the printer is sold. Do not convert operating voltages. This can damage the printer and void the product warranty. The following environmental specifications must be maintained to ensure the correct operation of the printer. Consider the following points before installing the printer: Place the printer on a sturdy, level surface. Allow adequate space around the printer for unimpeded operation. Install the printer in a well-ventilated room. Prevent exposure to direct sunlight or chemicals, including ammonia-based cleaning solutions.
Ensure that an adequate power supply is used. Install the printer in environment where no abrupt temperature or humidity changes occur. Table 5. Environmental specifications Table 6. Noise-level specifications Note Testing per International Standards Organization (ISO) 9296.
C8519-90912 Product specifications 19 HP LaserJet 9000 HP LaserJet 9000n/ 9000dn HP LaserJet 9000hns Height 600 mm (23.6 in) 600 mm (23.6 in) 1036.4 mm (40.8 in) Width 990.8 mm (39.0 in) 1115.8 mm (44.4 in) 1788.2 mm (70.4 in) Depth 1001 mm (42.7 in) 1001 mm (42.7 in) 1001 mm (42.7 in) Weight (without print cartridge) 63.5 kg (140 lb) 9000n, 69.4 kg (153 lb) 9000dn, 76.2 kg (158 lb) 76.2 kg (158 lb) Volts Frequency Amperes (A) Watts (W) (typical) Thermal units per hour (BTu/hr) 100-127 Vac ± 10 percent 50/60 Hz ± 2 Hz Minimum recommended current capacity = 15 amp dedicated circut printing = 1040 W standby = 265 W PowerSave 1 = 40 W PowerSave 2 = 25 W off = 0 W printing = 3550.36 BTu/hr standby = 904.71 BTu/hr PowerSave 1 = 136.56 BTu/hr PowerSave 2 = 85.35 BTu/hr off = 0 BTu/hr 220-240 Vac ± 10 percent 50/60 Hz ± 2 Hz Minimum recommended current capacity = 6.5 amps printing = 995 W standby = 265 W PowerSave 1 = 40 W PowerSave 2 = 25 W off = 0.2 W printing = 3396.93 BTu/hr standby = 904.71 BTu/hr PowerSave 1 = 136.56 BTu/hr PowerSave 2 = 85.35 BTu/hr off = 0.69 BTu/hr Operating/printing Storage/standby Temperature (printer and print cartridge) 10 degrees to 32.5 degrees C (50 degrees to 90.5 degrees F) -20 degrees to 40 degrees C (-4 degrees to 104 degrees F) Relative humidity 20 percent to 80 percent 15 percent to 90 percent Operator position Bystander (1m) Sound power Printing at 50 ppm L 59 db(A) Pam L 55 db(A) Pam L 7.1 db(A) WAd Idle L 43 db(A) Pam L 41 db(A) Pam L 6.0 db(A) WAd PowerSave L inaudible Pam L inaudible Pam L inaudible WAd