Notes: • Install the SmartLinx card so that the mounting holes align and the pin connectors mate correctly • Correct cable routing is important for electromagnetic noise suppression. Follow the routing instructions contained in the unit’s instruction manual. DIP Switches Refer to the following diagram to view the DIP switches. DIP Switches 1 to 8 must be in the ON position to allow the selection of Media Access Control (MAC) ID and data rate.
Cable Connector AiRanger / SITRANS LU Series, CraneRanger, InterRanger DPS 300, EnviroRanger ERS 500 (Wall Mount), MultiRanger 100/200, HydroRanger 200, Milltronics BW500, and Milltronics SF500, Installation Connect the DeviceNet card using cable which conforms to DeviceNet specifications and terminate according to the network requirements. bus power negative (black) CAN low (blue) cable shield (bare) CAN high (white) bus power positive (red) 7ML19981BH02 SmartLinx DeviceNet – Instruction Manual Page 7