Accumulator assembly (stapler/stacker only) 1 Remove the front cover, the back cover, the controller PCA cover, the flipper assembly, and the carriage assembly. Note While it is possible to remove the accumulator assembly without first removing the carriage assembly, HP strongly recommends that the carriage assembly be removed before removing the accumulator assembly. Otherwise, you might find it very difficult to reposition the accumulator assembly with the carriage assembly in the way. 2 Disconnect the ribbon cable (callout 1) from the controller PCA by pressing the black tabs to release the cable. 21 Figure 197.
Accumulator assembly removal (1 of 2) 3 Push the ribbon cable up through the hole. EN 3,000-sheet stapler/stacker and 3,000-sheet stacker 347