DeviceNet Slave Communication Module IFD9502 setting. Instance2 EEPROM read/write: setting, change Attribute30 of Instance2 of Class 0x9F into H’0001 and re-power IFD9502. In the custom mode, if you are to return the I/O mapping of AC motor drive to default change Attribute71 of Instance2 of Class 0x9F into H’0001 and re-power IFD9502. In the custom mode, if you are to return the I/O mapping of PLC to default setting, default setting, change Attribute90 of Instance2 of Class 0x9F into H’0001 and re-power In the custom mode, if you are to return the I/O mapping of temperature controller to IFD9502.
In the custom mode, if you are to return the I/O mapping of servo drive to default setting, change Attribute150 of Instance2 of Class 0x9F into H’0001 and re-power IFD9502. In the custom mode, if you are to return the I/O mapping of HMI to default setting, change Attribute224of Instance2 of Class 0x9F into H’0001 and re-power IFD9502. default setting, change Attribute200 of Instance2 of Class 0x9F into H’0001 and re-power In the custom mode, if you are to return the I/O mapping of the custom equipment to IFD9502. Common Services: Instance3 Modbus baud rate setting Note 1: The baud rates of the codes are in the table below.
DVP-PLC Application Manual 25 Attribute ID (decimal) Access rule Name Default 30 Get/Set AMD reset parameter H’0000 71 Get/Set PLC reset parameter H’0000 90 Get/Set DTA reset parameter H’0000 150 Get/Set ASDA reset parameter H’0000 224 Get/Set DOP reset parameter H’0000 200 Get/Set Custom reset parameter H’0000 Service Code Implemented for Service name Class Instance 005 Yes Yes Reset 0x0E Yes Yes Get Attribute Single _ _ 0x10 No Yes Set Attribute Single _ _ Attribute ID Range Default value Access rule Name (decimal) (Note 1) (Note 1) 1 Get/Set AMD baud rate setting 1 ~ 2 2 2 Get/Set PLC baud rate setting 1 ~ 4 4 3 Get/Set DT baud rate setting 1 ~ 2 2 4 Get/Set ASDA baud rate setting 1 ~ 4 4 5 Get/Set DOP baud rate setting 1 ~ 4 4 6 Get/Set CUSTOM baud rate setting 1 ~ 4 1