ASSEMBLY AND DISASSEMBLY V DISK DRIVES {} 1. Remove chassis bridge assembly as in Section IIV. 2. Remove M3 x 6mm screws pe! drive (4). 3. With assembly tilted vertically as shown in above, slide out disk drive. 4. Eject button and spring will be left in front bezel-note orientation of button. These components are a loose fit - do not lose. WARNING - Chassis is jigged in factory, do not move inner side cheeks. Assembly 1. With assembly tilted vertically as shown, install eject button and spring orientating button correctly. 2. Slide disk drive between side cheeks, taking care the LED correctly locates in its aperture. 3. Reverse of above procedure.