X6DHR-TG Motherboard Addendum: Memory Speed Jumper Settings and More (EN)

Addendum to X6DHR-TG Motherboard User’s Manual Attention!! Important Notice!! (Read the information listed below before using this product.) Jumpers J4F4/J4F5 (PLLSEL Select): These jumpers allow the user to select PLLSEL (Memory Speed). Make sure that the jumper settings are set correctly according to your memory speed before you power on the system. (*Warning!! If these jumpers are not set correctly according to your memory speed, video display failure may occur!!!) PLLSEL Select Jumper Settings (J4F4/J4F5) (*Note: the default setting is “Closed” for both jumpers to enable DDR Memory at 333MHz.

However, if your memory speed is 266MHz, please make sure to set both jumpers to “Open”.) DDR *333 MHz 266MHz (*Default:Closed-333MHz) J4F4/J4F5 4 Pin PWR 8 Pin PWR Mouse K B DIMM 1A 20-Pin ATX PW PW SMB Bank1 12V 12V JP11 U S B 0/1 DIMM 2A DIMM 1B DIMM 2B Bank2 CPU1 PWR Fail JP10 COM1 DIMM 4B DIMM 3B DIMM 3A DIMM 4A Bank3 Bank4 FAN1 FP CTRL E7520 J4F4 J4F5 FAN2 GLAN CTRL (North Bridge) CPU2 GLAN1 PCI-X 133 MHz SATA0 SATA1 Fan5 Fan4 J3 J4 JWF1 JP17 Floppy IDE #2 IDE #1 GLAN2 VGA S I/O Graphic Memory ZCR RAID IPMI 2.0 JS10 JPS1 WOR JWF2 JP18 RAGE- XL P X H ICH5R (South Bridge) Marvell SATA#0-3 SATA SPKR JPL1 Battery SATAII J S 9 Fan3 WOL Add-X6DHR-TG-11/10/04 J4F4 J4F5 HzClosed Open Closed Open PCI-X 100 M Hz PCI-Ex8 BIOS USB2/3 JWDJOH1JL1J D JPG 1 SM B IPM B COM 2

Стр. 1