Before using for the first time en 3. To place the accessory at shelf positions with pull- Note: The pull-out rails lock in place when they are fully pulled out. Gently push the pull-out rails back into the cooking compartment. out rails, pull out the pull-out rails. Wire rack or baking tray Position the accessory so that its edge is behind the lug on the pull-out rail. 4. Push the accessory all the way in, making sure that it does not touch the appliance door. Note: Take any accessories that you will not be using out of the cooking compartment while the appliance is in operation. 6 Before using for the first time Configure the settings for initial start-up.
Clean the ap- pliance and accessories. 3. Some parts are covered with a protective film. Re- move this scratch protection film. 4. Clean the outside of the appliance with a soft, damp 6.1 Setting the time cloth. 5. Clean the cooking compartment with hot soapy wa- Once the appliance has been connected to the power supply, three zeros flash on the display. Set the time. 1. Press . 2. Use or to set the time. Note: Once the set time has elapsed, the time is auto- matically saved. ter. 6. To eliminate the new-appliance smell, heat up the empty appliance with the door closed. 7. Turn the function selector to . 8. Set the maximum temperature.
If you are heating up the appliance for the first time, you may hear crackling noises from the cooking compartment. 9. Ventilate the kitchen while the appliance is heating. 10. Switch off the appliance after 1 hour. 11. Allow the appliance to cool down. 12. Once the cooking compartment has cooled down, 6.2 Cleaning the appliance before using it for the first time Clean the cooking compartment and accessories be- fore using the appliance to prepare food for the first time. 1. Remove the accessories from the cooking compart- clean the smooth surfaces with soapy water. 13. Install the rails. → Page 14 14. If necessary, clean the door panels. → Page 14 ment and remove the shelves. → Page 14 2.
Completely remove any leftover packaging, e.g. small pieces of polystyrene, from the cooking com- partment. 6.3 Cleaning the accessories ▶ Clean the accessory thoroughly with soapy water and a soft dish cloth. 7 Basic operation 4. Close the appliance door carefully. 5. Use the temperature selector to set the temperature. 7.1 Switching on the appliance WARNING ‒ Risk of explosion! If gas is collecting in the cooking compartment, this may cause an explosion in the cooking compartment during ignition. ▶ If the burner does not ignite after 15 seconds, switch off the appliance and open the door or a win- dow in the room. ▶ Wait at least 1 minute before igniting the burner again.
Do not turn the temperature selector beyond the minimum setting. a The appliance starts heating. Note: Use the function selector to set the additional functions. 7.2 Changing the type of heating and temperature 1. Open the appliance door. 2. Press the temperature selector and set it to the ▶ Use the temperature selector to change the temper- ature. maximum setting. 3. Press and hold the temperature selector for a few 7.3 Switching off the appliance seconds until the flame stabilises. ▶ Turn the temperature selector to the off position. 9