POWER TAKE OFF 00-47 20. Oil Seal (Output Shaft Side) 21. Rear Ball Bearing Pry the oil seal by a screwdriver and remove it, then strike the rear ball bearing from the rear side of the gear case and remove it. Bearing installer: 5-8840-2432-0 NPA0110E Legend 1. Rear case 2. Oil seal NPA0108E 25. Spring Pin 26. Cable Connector 27. Inner Rod 28. Spring Pin 29. Stopper Adapter Legend 1. Rear ball bearing 22. O-Ring Remove the cable connector or stopper adapt- er from the inner rod as requested. Remove the O-ring from the shift rod hole of the gear case.
Inspection and Repair Make necessary correction or parts replacement if wear damage, or any other abnormal conditions are found through inspection. Gear Case Inspect that there is a crack, a wear, or a scratch in each portion of the gear case and replace the gear case if there is a remarkable wear or scratch. NPA0120E Legend 1. O-ring 2. O-ring groove 23. Oil Seal (Shift Rod Side) Remove the oil seal from the gear case. 24. Gear Case NPA0111E