2. The following fittings are greased weekly, or every 50 hours. See Figure 3-1. 4. The following fittings are greased every 500 hours. See Figure 3-1. A. Rear axle pivot, 1 place on each side of machine. See Figure 3-8. A. Center bearing (1, Figure 3-9) of front drive shaft. Grease from a remote grease point (3, Figure 3-4). 1. Center Bearing FIGURE 3-9 2865 Two universal joints and one spline for front drive shaft. See Figure 3-10. FIGURE 3-8 2823 B. Two universal joints and one spline for rear drive shaft. See Figure 3-10. B. Steering cylinder rods, 1 place on each side of machine. See Figure 3-8. C. Steering cylinder head ends, remote greasing. One place on each side of machine.
See Figure 3-8. 3. The following fittings are greased every 250 hours. See Figure 3-1. A. Center pins, upper and lower. Two places on each side of machine. See Figure 3-8. FIGURE 3-10 2824 3-6 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual