PRECAUTIONS TO BE TAKEN DURING MAINTENANCE 2.8.3 PERSONNEL q Any maintenance operation must be carried out exclusively by authorized and duly trained personnel; specific and personal protection measures must be adopted when grinding, welding and when using sledges or heavy hammers. q When assembling the equipment or cylinder connection pins, use wooden, plastic or in any case not excessively hard tools to check the centering of the holes. Do not use your fingers, since you run the risk of cutting them off.
2.8.4 EQUIPMENT q The normal or special equipment that must be installed on the machine or that have been removed must be stored in a safe place and positioned in such a way as to prevent them from falling down. If they fall on someone, they may cause serious bodily harm. q When assembling or removing any equipment, make sure that the ropes and the lifting hook are in good conditions and properly dimensioned for the load to be lifted. RWA01320 2.8.5 WORKING UNDER THE MACHINE q Before performing service or repairs under the machine, always lower the work equipment to the ground or in any case lower it as much as possible. q Always lock the tyres of the machine securely.
q Avoid working under the machine if it isn’t properly supported. RWA02520 53