OAV ;T88blO AW1 ;R40133 R70;070300 1175 150288 CTM-7 (5-89) 2R3; 005 10 110589 Standard Drive Shaft Through Drive Shaft 1000 Series (PRJ-Hydraulic Pump IMPORTANT: DO NOT use grease to hold needle rollers. Doing so can restrain roller movement and cause pump failure. Use only clean hydraulic oil. IMPORTANT: Thrust washers on standard drive shaft must be installed with flat side against race. IMPORTANT: Spacers on through drive shaft must be installed with chamfered 10 toward the shaft journal. 1. Assemble shaft using 33 needle rollers (C) between race (D) and shaft journal. IMPORTANT:
Taper roller bearings on THROUGH DRIVE SHAFT must be pressed onto pump shaft even If shaft has not been disassembled. This assures correct pump shaft end play. 2. For through drive pump shaft, install smaller bearing cone on long splined end of shaft and larger bearing cone on short splined end of shaft. 05-10 A-Pump Shaft 8- Thrust Washers C-Needle Rollers D-Race *E-Spacer ASSEMBLE PUMP SHAFT *Through Drive Only AllTractorManuals.com Litho in U.S.A.