SECTION 1 Page 50 OPERATION STARTING IN COLD WEATHER When starting the engine in low temperatures, do as follows. I---- I 1. Turn the key in starting switch (1) to the START position I OFF 2 Move ether injection switch (2) to the ON position, then release it immediately. (Do not hold it at the ON position for more than 5 seconds. This will cause failure of the solenoid.) * If the engine does not start, repeat this 2-3 times. 3. When the engine starts, release the key in starting L switch (1) to return it to the ON position. WARNINGI Never operate ether injection switch (2) except when starling the engine. a * The ether cylinder can be used for about 230 times. (Amount of ether injected, 3cc.
total capacity for one cylinder 710~~) * The standard specification machine is designed to work in ambient temperature from -20 to 40°C. When operating the machine at temperatures below -20-C, special equipment is needed Contact your distributor for details. OFF * For machines where the air dryer is installed as an O+ option, in cold temperatures below -lO”C, when operating the machine after it has been stopped for U-J several hours. run the engine for at least 10 minutes -“p after stariing before moving the machine. . 3