4800/4900/6900 Tail Light Configurations Partially protected Single Unit Tail lights mounted Outside of Frame Taillight units are protected on three sides by a simple open box housing mounted on the outside of the frame Boxed tail lights (stop/tail/backup) mounted outboard of rails Unprotected Single Unit Tail lights 294-049 Taillight units are unprotected and mounted off brackets located on end of from crossmember 4.0” 294-052 Vsm dual sealed inboard of rail mounted stop/tail/turn/backup lights 7.38” 294-032 Flush mounted stop/tail/backup lights mounted below rear most crossmember Boxed tail light assembly (stop/tail/ backup) mounted outboard of rails and inset 4" from end of frame 294-1AC 294-1AJ Boxed tail light assembly with LED stop/tail/license plate lights and incandescent backup lights mounted below rear most Crossmember 8.0” Partially Protected Single Unit Tail Lights Under Frame Taillight units are supported from a simple angle plate mounted under end of from crossmember Partially protected Single Unit Tail lights mounted Under Frame LED stop/tail with separate backup lights mounted on polished aluminum plate end of frame Taillight units are protected on three sides by a simple open box housing Mounted under the end of frame 294-060 Vsm dual sealed polished aluminum plate mounted stop/tail/turn/backup lights 294-040 Boxed tail light (stop/tail/backup) mounted below the rails 294-063 4.0” 7.38” 25.63” 2.0” 8.0” 7.0” Page 1A-26 Rev (2.3) - Feb 2015