Operation From the operation page, an operator can power on the spreader, enter the menu, or spinner speed. Main Menu Pressing the menu button will enter the main menu. Once in the main menu, the user can select the following: Default Motor Controls Settings Menu Selecting settings from the main menu will enter the settings menu. From the settings menu, the user can select the following: Display to select the brightness level. CAN, to enable/disable the CAN terminator resistor. NOTE: In order to control the Gate/Vibe motor the Spinner/Auger must be active, if it is not active the Gate/Vibe label state will blink indicating the motor is disabled. Exit, go back to main menu.
10 LP69910 (12/07/2020) 3 CU FT GATOR FERTILIZER SPREADER Starting and Stopping Spreader Press the ON button to turn on the spinner/auger. Press the OFF button to turn off the spinner/auger Gate/Vibe Control Press the OPEN/ON button to open the gate or to turn on the vibe. Press the CLOSE/OFF button to close the gate or to turn off the vibe. Adjusting Motor Speed Press the bottom left button (down arrow) to decrease the speed of the motor in 11% increments. Press the bottom mid button (up arrow) to increase the speed of the motor in 11% increments. Entering the Menu Press the bottom right button (menu) to enter the menu. Menu Options Diagnostics Review the warning and fault list.
Maintenance Displays maintenance menu with options to reverse auger. Settings Adjusts the parameters of the display. System Display system’s voltage and temperature. Support Displays support information. Controller Info Displays controller information Display Info Displays system information. Exit Returns to the home page.