Operation Display Screen Messages During operation a message may appear describing a potential issue or problem. 11 LP69910 (12/07/2020) 3 CU FT GATOR FERTILIZER SPREADER Motor Over Current A motor is drawing too much current. Spreader will shut down, display an error message, and prompt the operator to reset the spreader. The spinner disk may be jammed and needs to be cleared. Motor Open Circuit This message is displayed when a motor is disconnected. Ensure that all harnesses are installed correctly, and connectors are fully seated. Ensure that the status light on the motor controller is green.
Voltage High This message is displayed when the controller is receiving a voltage higher than 16V. Please check battery voltage. Voltage low This message is displayed when the controller is receiving a voltage lower than 9V. Please check battery voltage. No Comm This message is displayed when there is a loss of communication with the motor controller. Ensure that all harnesses are installed correctly, and connectors are fully seated. Ensure that the status light on the motor controller is green.