. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WITH TRAILERS WARNING When loading or unloading, always use ramps or a platform. Proceed as follows. LOADING 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the brakes on the trailer securely and insert blocks (1) under the tires to hold the trailer in position. Set the distance (3) between ramps (2) to match the distance between the left and right tires, and make angle (4) of the ramps a maximum of 15 ° . If ramps (2) sag appreciably under the weight of the machine, put wooden block (5) under the ramps to support them. 3.
Determine the direction of the ramp, then slowly load the machine. 4. Load the machine correctly in the specified position on the trailer. 3 - 155 TRANSPORTATI When transporting the ma chine, observe all related laws and regulations, and be care TRANSPORTATION P When transporting the m dimensions shown in "SPE CIFICATIONS (PAGE 5-2)".
Note that machine specificatio ns (weight and dimensions) vary depending on the kin When loading or unloading the machine, run the engine at low speed, travel at low speed, an When loading or unloading In addition, keep well away Use ramps of ample width, length, thickness, and strength, and install them securely at an an When using an embankme nt, compact the fill soil thoroughly and make sure that the slope fa Remove the mud stuck to t he undercarriage to prevent the machine from slipping to the side In addition, remove any wa ter, snow, ice, grease, or oil from the ramps. the ramps. There is danger that the machine may tip over.
Never change direction on If it is necessary to change direction, return to the ground surface or the trailer platform, corre ct the direction, and start again. The position of the center o f gravity of the machine will change suddenly at the connection o f the ramp and trailer, and there is danger of the machine lo sing its balance. Always drive slowly over this point.