. OPERATION DETAILED CONTROLS AND GAUGES Swing Brake Cancel Switch NOTICE holding shown on the display, move this switch up to make Pump Drive Emergency Switch system shown on the display, move this switch up to make 3 - 18 This switch is installed to m ake it possible to carry ou t operatio n temporarily if a ny abnormality shou ld occur in the swing brake system. It i s not intended f or permanent us e. Repair the caus e of the abnormality immediatel This switch ( 7) is used to m ake it tempora rily possible to c swing operat ions if any a bnormality occu rs in th e swing brake system (when "E03" is shown on th (a) Cancel: W hen there is abnormality (sw itch moved up) (b) Automati c:
Normal pos ition (switch mo If "E03" is s operations p NOTICE This switch is installed to make it possible to carry out oper ation temporaril y if any abnormality should oc cur in t he pump control sys tem. It is not int ended for perma nent use. Repair t he cause o f the abnormality i mmediately. If this switc h is depressed and moved to th e EMERGENCY p osition by mistake, thereby e ngaging the mach ine in the work, while the m achine is in nor mal condition, an "E02" m ark is sh own in th e display. If "E02" is d isplayed during the work, check that the switch is in the NORMAL position.
This switch ( 8) is used to m ake it tempora rily possible to c operations if any abnorma lity occurs in th he display). (when "E02" is shown on t (a) Cancel: W hen there is abnormality (sw itch moved up) (b) Automati c: Normal pos ition (switch mo ved down) If "E02" is s operations p