Operator Cab and Controls - Section 32 08/11 OM3212 Page 32-32 The possible action codes are as follows: 6. Screen i7, Back Light Off Two faults can be displayed at one time along with their description and action. If three or more code are present the "FWD" and "REV" touch areas on the i6 screen can be used to view the other codes. The number that is assigned to each code, is the order of occurrence. Number 1 would be the oldest code and as the numbers increase the newer the code. This i7 screen shows the back light of MOM turned off and nothing indicated. Use this screen at night when the lighted display is too glaring.
When in i3 or i4, by touching "LIGHT OFF" the display will switch to i7. If any area of the i7 screen is touched the dis- play will return to i2, i3, or i4 depending on the condi- tion of the truck. If a fault is detected while in the i7 screen, the display will automatically return to the i6 screen with the back light on. If the fault code display in MOM is not a serious code requiring immediate action, the code can be cleared from the screen by touching the number of each fault located at the left side of the code number. However, this action only erases the code in MOM. This is still an active fault, and the electronic display panel will keep indicating the action code.
The central warning lamp will also remain activated. Once the fault code is erased from MOM the same code will not appear again until the code is recovered or unless the fault occurs again. When all of the faults are recovered or cleared from MOM the screen will return to i2, i3, or i4 automatically according to the truck condition. The possible action codes are as follows: Code Description 01 Notify maintenance at shift change 02 Notify maintenance right now 03 Reduce engine / machine speed 04 Stop safely now / shut off engine 05 Stop with engine at mid speed 06 Start engine and keep at low idle 07 Keep body seated