5 [5] ASSEMBLY PROCEDURE (1 ) Installation of tire and wheel assembly (1) INSTALLATION OF TIRE AND WHEEL ASSEMBLY 1) Positioning of vehicle 1. Sling the front side and rear side of the chassis with a crane. 2. Position the vehicle on wood blocks, etc. by the underside of the axle housing. Set the vehicle so that the center of the axle will be 1.1 – 1.2 m above the ground. 3. Since the rear axle oscillates, put wood blocks between the rear axle and rear frame to prevent the axle from leaning. 2) Removal of axle stand 1. Remove the stand (Jig No. AZ-001-051) installed to the axle. 3) Slinging of tire and wheel assembly 1. Sling the tire and wheel assembly with the crane.
At this time, match the mounting holes of the wheel to the studs on the axle side. Sling: Endless chain sling or endless ny- lon sling: 2 pcs 2. Sling the tire and wheel assembly slowly so that it will not lean. Precautions Special tools Necessary devices Name Q'ty Name Q'ty Crane (25 ton), 50 Ton 1 each Endless chain sling 2 Other remarks (1 )