CAB AND FRAME 2-43 Door Lock Assembly N2A0077E Legend 1. Door trim pad 3. Glass run rear channel 2. Water-proof sheet 4. Door lock assembly Removal 1. Door trim pad 2. Water-proof sheet Refer to “Window regulator” in this Section. 3. Glass run rear channel Pull out the 2 mounting screws. 4. Door lock assembly Disconnect each link and remove the 3 mount- ing screws. Installation For installation, reverse the removal procedure taking the following points into consideration. 1. Tighten the door lock assembly to the specified torque. Tighten: 15 N m (1.5 kg m/11.1 lb ft) 2. After installation, check the operation.