CAB AND FRAME 2-89 Removal and Installation of Cab Assembly N2A0145E Legend 1. Cab stay pin/nut (Tilt cab model) 5. Frame side mounting lever (Non-tilt cab model) 2. Floor 6. Cab side front mounting rail (Non-tilt cab model) 3. Cab assembly 7. Frame side front mounting lever (Tilt cab model) 4. Cab fixing bolt 8. Cab side front mounting rail (Tilt cab model) Removal Perform the work surely according to the proce- dure fit for the mounted engine. 6. Parking brake control cable Preparations Before removal or installation of the cab assembly, remove the following connections. The removal or- der is free. However, perform each step surely re- ferring to each workshop manual. 1.
Heater hose/air conditioner piping Refer to “Parking Brake”. 7. Steering linkage Refer to “Steering Linkage”. 8. Harness connector/frame earth bolt Refer to “Heater and Ventilator” and “Air Condi- tioner”. 2. Accelerator control cable Refer to “Electrical Equipment”. 9. PTO control cable Refer to “Power take-off (PTO)”. Perform the work surely according to the proce- dure fit for each type of PTO. Refer to “Fuel System” in Section 6C. Perform the work surely according to the procedure fit for the mounted engine. 3. Brake fluid piping After disconnecting all the above connections, tilt the cab for a tilt cab vehicle or remove the rear mounting connection for a non-tilt vehicle.
For removal of the rear mounting, refer to “Cab mounting” in this Section. 10. Cab stay pin and nut (tilt cab vehicle) 11. Cab mounting bolt 12. Cab assembly Refer to “Hydraulic Brake”. 4. Hydraulic clutch piping Refer to “Clutch”. 5. Gear control cable Refer to “Gear Control Cable”.