52 SEBU8726-03 Operation Section Configuration Parameters (Table 3, contd) (continued) Throttle Position 1 Engine Speed Throttle Position 2 Engine Speed Throttle Position 3 Engine Speed Throttle Position 4 Engine Speed Engine Idle Shutdown Enable Status Engine Idle Shutdown Delay Status Throttle Lock Feature Installation Status Multi State Input Switch Enable Status Multi State Input Switch Control Purpose Multi Position Throttle Switch Initialization Enable Status Throttle Lock Engine Set Speed #1 Throttle Lock Increment Speed Ramp Rate Throttle Lock Decrement Speed Ramp Rate Throttle Lock Engine Set Speed Increment Monitoring Mode Shutdowns Limp Home Desired Engine Speed Engine Acceleration Rate Engine Location High Exhaust System Temperature Indicator Installation Status Oil Pressure Lamp Installation Status Wait to Start Lamp Installation Status Warning Lamp Installation Status Shutdown Lamp Installation Status Starter Relay Installation Status Low Pressure Fuel Pump Installation Status Remote Torque Speed Control Enable Status Throttle Arbitration Method Manual Throttle Arbitration Precondition Check Throttle Enable Status Throttle #1 Initial Lower Position Throttle #1 Initial Upper Position Throttle #1Idle Validation Switch Enable Status Throttle #1Idle Validation Minimum Off Threshold Throttle #1 Idle Validation Maximum On Threshold Throttle #1 Lower Diagnostic Limit Throttle #1 Upper Diagnostic Limit Throttle #2 Initial Lower Position