OPERATING THE MACHINE OPERATING THE MACHINE PREPARING THE WORK EQUIPMENT SELECTING A WORK UNIT Refer to chapter "Equipment" for information on the work units registered. PICKING UP THE WORK UNIT (EXCEPT MULTI- PURPOSE BUCKET) Connect the multi-purpose bucket as described in section „Pick- ing up the multi-purpose bucket“ (see next page). 2 1. Make sure that the change-over lever for the additional con- trol unit is in position '2' (fig. 75_160). 2. Start the engine. 3. Unlock the quick-change unit by setting the control lever for special equipment into position ‘1’ (fig. 75_042). 4. Lift the boom slightly by setting the multi-function lever into position ‘H’ (fig. 75_016). 5.
Tilt the quick-change unit slightly to the front by setting the multi-function lever into position 'A' (fig. 75_016). 6. Drive the machine to the work unit until the quick-change unit (3) is below the pickup hooks of the work unit. Then, lift the boom until the work unit catches the quick-change unit (fig. 75_280). 7. Tip in the quick-change unit until the work unit is connected to the limit stops on the the quick-change unit by setting the multi-function lever into position ‘E’ (fig. 75_016). 8. Lock the quick-change unit by setting the control lever for special equipment into position ‘2’ (fig. 75_042). The interlocking pins (4) will then be visible (fig. 75_280).
1 75_160 2 3 0 1 75_042 If the work unit is not properly attached, it can suddenly fall down and cause severe accidents! Carefully lift the work unit and check whether it is com- pletely locked in by slowly tipping it in and then dumping it. 75_016 9. Check whether the work unit is completely locked in by tip- ping it in and then dumping it. 3 4 75_280 5-25