TROUBLESHOOTING STARTING THE ENGINE The engine of the machine with the charged battery must run at high idle-running speed. Start the engine of the machine with the discharged battery. If the engine does not start up immediately, wait at least two minutes, before you make a second attempt. DISCONNECTING THE BATTERY JUMPER CABLE Danger of short-circuit! When disconnecting the cables, pay attention not to let the cable ends touch each other or the machine. When the cable ends touch each other or the machine, a short-circuit is produced which may damage parts of the electrical system! When disconnecting the cables, pay attention not to let the cable ends touch each other or the machine.
After starting of the engine, disconnect the battery jumper cables by reversing the steps you performed to connect the cables. 1. Disconnect one clamp of the battery jumper cable from the engine block. 2. Disconnect the other clamp of the battery jumper cable from the negative terminal (-) of the charged battery. 3. Disconnect the clamp of the battery jumper cable from the positive terminal (+) of the charged battery. 4. Disconnect the other clamp of the battery jumper cable from the positive terminal (+) of the discharged battery. 6-13