TROUBLESHOOTING 8.2 8.2E Control Levers 8.2F Electrical 8 8-10 Symptom Cause Remedy Control levers will not center Linkage out of adjustment Adjust, check for wear at rod ends, loose counter nuts Linkage discon- nected Reconnect, check for wear at rod ends, loose counter nuts Centering spring broken Replace Linkage binding Control levers binding with safety shields or sound insulation Adjust control lever bearings binding in lever assy. Inspect replace or clean as required Machine oper- ates erratically Control lever link- age loose Inspect linkage for wear at rod ends, loose counter nuts Bolt in pintle lever loose or broken Replace bolt.
Ensure bolt clamping lever to pump shaft is tight See troubleshooting hydro- static system Machine loses power while turning See troubleshooting hydro- static system Machine will not travel in straight line Linkage binding Adjust Control lever trav- el out of adjust- ment Adjust Control levers do not operate smoothly Internal pump and / or motor leakage Control lever link- age out of adjust- ment See troubleshooting hydro- static system Adjust control lever link- ages Control lever link- ages need lubrica- tion Lubricate Symptom Cause Remedy Engine will not crank over Battery failure Check battery, charge or replace Battery cable fail- ure Check for loose or cor- roded connectors.
Tighten and clean as required. Use di-elec- tric grease to prevent corrosion. Check continuity of cables and replace if defective Starter failure Repair or replace Fuse burnt Check and replace Defective relay Check relay continuity if defective, replace Ignition switch failure Check continuity and if defective, replace Engine cranks over, but will not start Auxiliary hydraulics engaged Engine will smoke but not run unassisted by starter. Disengage aux.
hydraulics Defective glow plug relay Check continuity and if defective, replace Defective glow plugs Check continuity and if defective, replace Broken connection or defective wire Check continuity of the circuit not functioning properly in both engine and ROPS harness. No fuel Check fuel levels and system Loader starts, but hyd. controls will not release Electro solenoid not releasing valve spools Defective solenoid or binding solenoid lock. Check continuity of connectors and wire.
Engine will not stop when the key is turned OFF Engine will not stop when the key is turned OFF Defective ignition switch Mechanical dam- age of the gover- nor Defective ignition switch Mechanical dam- age of the gover- nor Check and replace Check and repair or replace