. SAFETY SAFETY MAINTENANCE INFORMATION WHEN USING HAMMER turning off the engine starting 2 - 38 When using a hammer, pins may fly out or metal particle s may be scattered. This may lead to serious injury. Always do as follows. If hard metal parts such a s pins, bucket teeth, cutting e dges, or bearings are hit with a h might be scattered and c ammer, there is a hazard tha t pieces Always wear safety glasses and When hitting pins or buck et teeth, there is a hazard tha t broken pieces might be sent flyin g and injure people in the sur rounding area. Always check that t here is no one in the surround ingarea.
There is a hazard that th ut and injure people in the s WELDING WORKS Welding operations must alw ays be carried out by a qualifi ed welder and in a place equ ipped with proper equipment There is a hazard of gas, fir e, or electrocution when carry ing out welding, so never all ow any unqualified personne to carry out welding. REMOVING BATTERY TERM INALS the electrical system, wait for approx. one minute after t When repairing or welding switch key, and then discon nect the negative (-) terminal of the battery to stop the flo SAFETY FIRST WHEN USING HIGH-PRESSURE GREASE TO ADJUST TRACK TENSIO Grease is pumped into under high pressure.
If the specified procedure for maintenance is not follow ed when making adjustment, grea serious injury or property When loosening grease tension, never loosen it m ore than one turn. Loosen th e grease drain plug slowly. Never put your face, han ds, feet, or any other part of y our body close to grease drain plu