2. Product explanation 2.1 USE, DRIVING SYSTEM , ETC . The engine is equipped with marine gear, connect the marine gear output shaft to the propeller shaft. In order to obtain full performance from your engine, it is imperative that you check the size and structure of the hull and use a propeller of the appropriate size. The engine must be installed correctly with safe cooling water and exhaust piping and electrical wiring. The PTO work should be easy to use for onboard equipment.
To handle the drive equipment , driven systems (including the propeller) and other on board equipment,be sure to observe the instructions and cautions given in the operation manuals supplied by the shipyard and equipment manufacturers. The laws of some countries may require hull and engine Inspections, depending on the use, size and cruising area of the boat. The installation, fitting and surveying of this engine all require specialized know ledge and engineering skills. Consult Yanmar's local subsidiary in your region or your distributor or dealer . A WARNING Never modify this product or release the limit devices (which limit engine speed. fuel injection quantity , etc.).
Modification will impair the safety and performance of the product and functions and shorten the product l if e. Please note that any troubles arising from modification of the product will no t be covered by our warranty. DETAIL OF NAME PLATE The name plate shown below is attached to the engine. Check the engine's model, output, rpm and serial number on the name plate. The name plate shown below is described in the marine gear. Check the marine gear's model, gear ratio, oil used, oil quantity and serial number. __ , MODEL CONT.RAT IN G kW rpm v MOD EL KM MAX .OUT PUT kW rpm GEAR RATIO OIL SAE2 0IJo HD OIL QTY. LTR . NO . ENGINE NO. YliUfMA8 D~DHI.-E KIIIIZAICI ~ ..) OSAKA JAP AN 8