05-E2B, 05-E2BG, WSM G GENERAL [13] CHECK POINTS OF EVERY 2 YEARS Replacing Intake Air Line 1. Loosen the clamp (2). 2. Remove the intake air hose (1) and clamp (2). 3. Replace new intake air hose (1) and new clamp (2). 4. Tighten the clamp (2). NOTE Q To prevent serious damage to the engine, keep out any dust inside the intake air line. (1) Intake Air Hose (2) Clamp W1023867 Replacing Battery CAUTION When the battery is being activated, hydrogen and oxygen gases in the battery are extremely explosive. Keep open sparks and flames away from the battery at all times, especially when charging the battery. When charging battery, remove battery vent plugs.
When disconnecting the cable from the battery, start with the negative terminal first. When connecting the cable to the battery, start with the positive terminal first. Never check battery charge by placing a metal object across the posts. 1. Disconnect the negative terminal and positive terminal. 2. Remove the battery holder. 3. Remove the used battery. 4. Replace the new battery. 5. Tighten the battery holder. 6. Connect the positive terminal. 7. Connect the negative terminal. W1023996 Replacing Radiator Hoses and Clamp Bands CAUTION Do not remove the radiator cap when the engine is hot. Then loosen cap slightly to the stop to relieve any excess pressure before removing cap completely. 1.
Drain the coolant. 2. Loosen the clamp bands. 3. Remove the upper hose (1) and lower hose (2). 4. Replace new upper / lower hose (1), (2) and clamp bands. 5. Tighten the clamp bands. 6. Fill with clean water and anti-freeze until the coolant level is just below the port. Install the radiator cap securely. (1) Upper Hose (2) Lower Hose W1024178 G-24 KiSC issued 06, 2011 A