SAFETY PRECAUTIONS NOTICE: When welding, the following must be done to avoid damage to the electronic controls or the engine: Both the positive (+) and negative (-) battery leads must be disconnected before welding. Ground cable must be in close proximity to welding location - engine must never be used as a grounding point. Welding on the engine or engine mounted components is NEVER recommended. 2.5 WORK PLACE Organize your work area and keep it clean. PERSONAL INJURY To avoid injury from slipping and falling, immediately clean up any spilled liquids. Eliminate the possibility of a fall by: Wiping up oil spills Keeping tools and parts off the floor A fall could result in a serious injury.
After installation of the engine is complete: PERSONAL INJURY To avoid injury from rotating belts and fans, do not remove and discard safety guards. Reinstall all safety devices, guards or shields Check to be sure that all tools and equipment used to install the engine are removed from the engine 2-4 All information subject to change without notice. DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION