2010 GM/Isuzu Truck EPA Requirements q NPR/W3500 Gas, NPR/W3500 Gas Crew Cab, NPR/W3500 Diesel, NQR/W5500 Diesel, NPR HD, NQR/W4500, W5500 Diesel Crew Cab and NRR/W5500-HD Series Chassis Cab The following statement is applicable to all models of incomplete vehicles equipped with diesel engines. (Type 1) This incomplete vehicle, when completed, will conform to the above standard providing no alterations are made which affect the function, physical, chemical, or mechanical properties, environment, location or vital spatial clearances of the components, assemblies or systems including but not limited to those listed below:
-Injection Pump -Engine Coolant Temperature Sensor -Injector and High Pressure Lines -Intake Manifold -Turbocharger -Catalytic converter and its location -Charger Air Cooler and Charge Air Cooler Hoses -Exhaust Gas Recirculation System -Engine Control Module (ECM) -MAF Sensor -Engine Speed Sensor -DPD (Diesel Particulate Defuser) and its location The following statement is applicable to all models of incomplete vehicles equipped with diesel engines. (Type 2) This incomplete vehicle, when completed with the vertical exhaust system, will conform to the above standard providing it is completed by the fi nal stage manufacturer in accordance with the following specifi c conditions: a.
the incomplete vehicle manufacturer‘s vertical exhaust system kit is used, and b. the vertical exhaust system kit is installed to the vehicle in accordance with the incomplete vehicle manufacturer‘s instructions For more information on the kit and instructions, please call 770-740-1620 Ext.262 and 562-229-5240. The following statement is applicable to all models of incomplete vehicles equipped with gasoline engines . (Type 3) Conformity with On-Road Vehicle and Engine Emission Regulations cannot be determined based upon the components supplied on the incomplete vehicle, and ISUZU Motors makes no representation to conformity with the standard.
INTERFERENCE CAUSING EQUIPMENT STANDARD – ICES-002 Applies to all models of incomplete vehicles except vehicles equipped with diesel engines contained in this book TYPE 1 The following statement is applicable to all models of incomplete vehicles except vehicles equipped with diesel engines (unless otherwise noted on the cover of this document) This incomplete vehicle, when completed, will conform to the above regulations providing no alterations are made which affect the function, physical, chemical, or mechanical properties, environment, location or vital spatial clearances of the components, assemblies or systems including but not limited to those listed below:
-Ignition Wires & plugs -Ignition coil(s) -Spark plug wires U.S. ENVIRONMENTAL PROTECTION AGENCY AND STATE OF CALIFORNIA EMISSION EQUIREMENTS AND ON-BOARD DIAGNOSTIC SYSTEM (OBDII) REQUIREMENTS To assure that EPA and California emission certifi cate requirements and OBDII requirements are met, this incomplete vehicle (except where noted) must be completed in strict accordance with all instructions contained in this document, especially the following instructions which relate to: A. Exhaust emission related components B. Specifi cation for fi ll pipes and openings of motor vehicle fuel tanks (applicable only to California gasoline powered vehicles) C. Labels 2010 GM/Isuzu Truck PAGE 4