Operating Instructions for Starting the Engine NOTICE: Failure to connect jumper cables in the proper sequence can result in alternator and/or equipment damage. Before attempting to jump start the engine, the jumper cables must be connected properly; positive-to-positive, and negative-to-chassis or suitable ground. The proper sequence is to connect negative to negative ground last. Routine Engine Start The following are procedures for a routine engine start. WARNING: ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. WARNING:
PERSONAL INJURY To avoid injury when working near or on an operating engine equipped with an hydraulic clutch fan, remove loose items of clothing and jewelry. Tie back or contain long hair that could be caught in any moving part causing injury. The hydraulic fan may start without warning. Routinely Starting the Engine Before a routine start, see the daily checks for your engine in the Maintenance section of this manual. NOTICE: Before starting the engine, carefully read all operating instructions in this manual and do all the recommended pre-trip inspections and daily maintenance. Check the coolant, engine oil, and fuel levels, and drain contaminants from the water separator/coalescer.
Start the engine as follows: NOTE: If you drain water from the water separator/coalescer, you have to prime the fuel system with the built-in hand primer (about 50 strokes). NOTE: As a safety function, the electronic engine control system may be wired to start the engine only if the transmission is in neutral. This feature is vehicle application specific. 1. Turn on the ignition switch. 2. Wait for the engine system indicator lights on the instrument panel to go out. 3. With the accelerator pedal in the idle position, start the engine. 32 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209