24. SERVICE PROCEDURE 5. If small holes or thinner parts are found on the element when it is checked by shining a light through it after cleaning, replace the element. NOTICE Do not use an element whose folds or gasket or seal are damaged. When cleaning the element, do not hit it or beat it against anything. Wrap up unused elements and store them in a dry area. 6. Remove the cloth and tape used for cover in Step 1. 7. Install the cleaned element and fix it with the wing nut. 8. If seal washer v is damaged or the thread of wing nut x is broken, replace it with a new part. 9. Remove evacuator valve b and clean with compressed air. After cleaning, install again. Replacing the inner element 1.
First remove the cover and the outer element, and then remove the inner element. 2. To prevent dust from getting in, use a clean cloth or tape to cover the air connector (outlet side). 3. Clean the air cleaner body interior, then remove the cover installed in Step 2. 4. Fit a new inner element to the connector and tighten it with the nuts. Do not clean and reinstall the inner element. 5. Install the outer element and fix it with the wing nut. 6. Install the cover and fix it with the wing nut. PC450-ENG 3-25