5. Using the oil fi lter wrench and a ratchet handle (or a socket or boxend wrench), remove the old oil fi lter and dispose of properly. Do not re-use oil fi lter. 6. Apply oil to the new fi lter O-ring and check to make sure it is positioned correctly; then install the new oil fi lter. Tighten securely. 7. Install the oil fi lter drain plug and tighten securely. 8. Install the engine drain plug and tighten securely. Pour the recommended oil in the fi ller hole. Install fi ller plug. 9. Start the engine (while the ATV is outside on level ground) and allow it to idle for a few minutes. 10.Turn the engine off and wait approximately one minute. Recheck oil level.
11.Inspect the area around the drain plug and oil fi lter for leaks. Front Differential And Rear Drive Lubricant (Inspecting/Changing) Inspect and change the gear lubricant at the scheduled intervals. When changing the lubricant, use approved SAE 80W-90 hypoid oil and use the following procedure. 1. Place the ATV on level ground. 2. Remove each oil fi ller plug. Be careful not to allow contamina- tes to enter the opening. 3. Drain the oil into a drain pan by removing in turn the drain plug from each. 4. After all the oil has been drained, install the drain plugs and tighten securely. GENERAL MAINTENANCE 75