2. CONTROLS 2.2 CONTROL LEVER HANDLES Fully retract lift arm support pins before raising or lowering lift arms. IMPORTANT LH Control Handle RH Control Handle 1 2 5 6 3 17. Air Cleaner Indicator Light: This light will illuminate when there is an obstruction in the intake or when the air filter needs servicing. If this light illuminates, stop the engine and service the cleaner (see section 4.9). 8 4 7 18. Pre-heat Indicator Light: This light will illuminate when the ignition key is turned counter clockwise to activate the engine glow plugs. 19. Dipped Beam Light Switch: This switch is a toggle switch. Push up to turn the dipped beam lights on.
These lights are located on the front of the loader (not available on all models) . Fig. 2.2A C3015 Fig. 2.2B C3933 1. Two Speed Switch (not available on all models): This switch provides alternate switching. Press to activate Hi- Speed function. Pressing and releasing the switch a second time will return the loader to the Low-Speed function. (See Fig. 2.2A) 20. Rotary Beacon Light Switch: This switch is a toggle switch. Push up to turn the optional rotary beacon light on (not available on all models) . 2. Horn Switch (not available on all models): This switch is a momentary switch. Pressing and holding the switch will activate the horn. Releasing the switch deactivates the horn. (See Fig.
2.2A) 21. Hazard Light Switch: This switch is a toggle switch. Push up to turn the optional hazard light on (not available on all models) . 3 & 4. Electric Solenoid Auxiliary Switch: This switch is a momentary switch. Pressing and holding the switch in position 3 provides hydraulic flow to the female quick coupling. Pressing and holding the switch in position 4 provides hydraulic flow to the male quick coupling. Releasing the switch returns it to neutral, stopping the hydraulic flow. (See Fig. 2.2A) 22. Work Light Switch: This switch is a toggle switch. Push up to turn the optional work light on (not available on all models) . The light is located on the back of the loader. 23.
Auxiliary Hydraulics Front Switch: This switch is a toggle switch. Push up to provide a continuous flow of hydraulic oil to the quick couplers when using an attachment (not available on all models) . 5. LH Directional Signal Switch (not available on all models): This switch is a momentary switch. Pressing and holding this switch will activate the LH turn signal. Releasing the switch deactivates the LH turn signal. (See Fig. 2.2B) 24. Lift Arm Supports: For safety while performing service or maintenance, the loader is equipped with a lift arm support device. Refer to section 2.7 for details. 6. RH Directional Signal Switch (not available on all models): This switch is a momentary switch.
Pressing and holding this switch will activate the RH turn signal. Releasing the switch deactivates the RH turn signal. (See Fig. 2.2B) 25. Hi-Flow Hydraulic Switch: This switch is a toggle switch. Push up to turn the hi-flow hydraulics on (not available on all models) . 7 & 8. Hi-Flow Hydraulic Switch (not available on all models): This switch is a momentary switch. Pressing and holding the switch in position 7 activates the hi-flow hydraulics to the male quick coupling. Pressing and holding the switch in position 8 activates the hi-flow hydraulics to the female quick coupling. Releasing the switch returns it to neutral and stops the hi-flow hydraulic flow. (See Fig. 2.2B) 11