1.2. SAFE TRAVEL PERFORM A SAFETY CHECK BEFORE STARTING THE LIFT TRUCK Before starting the lift truck, check that the surrounding area is safe. Before moving the lift truck, raise the forks [approximately 15 to 20 cm (6 - 8 in) from the ground surface], and tilt the mast back. When ready to move, release the parking brake. BE SAFETY CONSCIOUS WHILE DRIVING Keep a clear view of the path of travel and watch for other traffic, personnel, and safe clearances. When passing oncoming vehicles, reduce speed and keep a safe distance from the other vehicle. In places where there are speed limits, observe the speed limit and maintain a safe distance from other vehicles.
When traveling, always pay careful attention to the area around your lift truck, particularly in the direction of travel or when turning. Do not attempt to pass another lift truck or vehicle on a narrow path or on a spot of limited view like a crossing. When passing through an area of limited view, like a crossing or when running into a narrow path, sound the horn and check the surroundings for safety. Even if you sound the horn, not everyone in the surrounding area will necessarily hear it. Always pay careful attention to the movements of people in the surrounding area. When crossing a passage or turning at a corner, stop the lift truck once to confirm the safety around.
Always pay careful attention to the movements of people in the surrounding area, and take steps to prevent people from entering the working area. When traveling on a slope or through a crowded spot, always give way (yield) to a loaded lift truck. DO NOT DRIVE ON ROUGH GROUND OR SURFACE Avoid traveling in places which are flooded or where there are holes. Do not try to drive the lift truck on soft ground. Avoid curbs, rails, ditches, or other obstacles, and do not travel directly over them. Do not travel on slippery road surfaces. When entering buildings, check the weight limit of the floor and be careful not to exceed the limit. 1-8