ASSEMBLY ASSEMBLY Preparation for assembly 1) Adjust the dimension of link press pushing tool to have protrusion of bushing and pin in the specification. In case pin end face is worn, adjust pushing tool by adding wear amount of the pin end to be specified dimension. (Refer "Press Jig dimension on the last part of page) 2) Adjust relief pressure of link press not to exceed press-fitting force (P4) over the specification. # The symbols in the each discription of works can be referred " PARTS STANDARD VALUE" table and "ASSEMBLY TOOL" table in this last part of manual. 3) In case large plug are removed, wash oil hole with tool (R2) , and put large plug with tool (R3) Example: P4, R2,------ 1.
Master Link assembly (bushing side) 1) Align link press push tool center with bushing center properly. # Bushing center becomes lower after 180 degree turn so re-centerlize with pushing tool is required. # outer diameter should be measured at disassembly to estimate alignment change. 2) Set a link and press bushing in the link. Target bushing press-fitting force (P2) should be be in the specification shown in the "Parts standard table". - 19 -