ASSEMBLY 3) Check bushing protrusion (L5) in the specification with depth gauge, which is shown in the "Parts standard table". 4) Set an other side link and align parallels with press fitted one, and press fit it. # Link shoe mounting face must be parallel, otherwise it will be difficult to connect master links and install shoe. 5) Check shoe bolt pitch with shoe bolt pitch gauge. Refer dimension (L9, L10 & L11) in the "Parts standard table". 2. Regular Link assembly 1) Turn master link sub-ass'y 180 degree. Put a bushing(1) on a press jaw, and put a pin(2) in a bushing. ( 1) # Turn bushing 180 degree as worn side comes upper side which is link shoe mating side.
Reverse left and right ends of pin as oil branch hole facing link tread side. ( 2) - 20 -