Starter/Starter 6. Install positive side brushes. Fasten with fiber washer, flat washer, lock washer, and nut. Tighten nut to 6 ± 1 N·m (53 ± 9 lb-in.). 7. Install negative brushes. Fasten with cap screws and tighten to 4.5 ± 0.5 N·m (40 ± 4.5 lb-in.). M37108 -UN-25JAN90 M37107 -UN-25JAN90 8. Install springs. M98,2060K,25 -19-05NOV85 9. To make temporary brush holders, cut steel banding into four pieces, 76mm (3 in.) long. Bend flanges 25 mm (1 in.) long as shown. 10. Push brushes down on the springs and hold them in place with the four brush holders. Make sure that chamfered side of brush is up and that the wires do not rub against the commutator or end cap.
M37116 -UN-25JAN90 M98,2060K,26 -19-05NOV85 CTM2 (19APR90) 60-12 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495 11. Apply a light film of grease to bushing (A). 12. Align tab and notch (B); then install end cap on starter. -UN-25JAN90 M37117 M98,2060K,27 -19-05NOV85 60 12