CLEANING AND STORAGE [c] Run the engine. Allow the engine to warm up to approximately 80°C (176°F), and then run it about five minutes longer. If the engine is to be out of service for over 12 months, or under extraordinary storage or transportation conditions, then special protective measures are necessary. Information is available from any authorized dealer. It is strongly recommended that you request this information. [d] Drain the hot water. 5. Fill the cooling system with new coolant. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, refer to “Coolant” in the “Service Products” section. Important:
If the engine is to be out of service for over 18 months, the oil must be changed before the engine can be brought back into service. Storage Required protective measures for the MBE 900 engine depend on the following: The length of time that the engine will be out of service The climate and conditions where the engine is stored After cleaning, engines should, whenever possible, be placed in a dry, well-ventilated area. In all cases, protect the engine against direct exposure to moisture (rain/splash water). If the engine is to be out of service for 12 months or less, anticorrosion measures are not necessary, provided that the place of storage are dry and well-ventilated as described above.
42 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0055 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION