. ATTACHMENTS, OPTIONS HANDLING LOAD METER ATTACHMENTS, OPTIONS HANDLING LOAD METER 3. This is the second load. The load in the bucket is 4.9 tons. 6.9 - 4.9 = 2.0 tons, so the next target load is displayed as 2.0 tons. 4. This is the third load. The result of measuring the load in the bucket is 5.0 tons. This is 3.0 tons over the target amount, so -3.0 tons is displayed. The amount remaining in the bucket is 3.5 tons. The target load is 2.0 - (5.0 - 3.5) = 0.5 tons The next target load of 0.5 tons is displayed. REMARK 6 - 21 5. The target load i the display chan The target value the loading of th 6. Load the target bucket. When this is don 7.
After loading, lo to weigh the am remaining in the s displayed as -3.0 tons, and after 3 seconds, ges to the display shown on the right. of 2.0 tons is the target load after completing e second bucket. of 2.0 tons from the 5.0 tons loaded in the If 2.2 tons is loade amount remaining in the target load has b At the same time, "T display. d when the target load is 2.0 tons, and the the bucket is displayed as 2.8 tons (5.0 - 2.2), een exceeded, so the alarm buzzer sounds. ARGET OVER" is displayed on the character cancel switch to stop the alarm buzzer.
Push the load meter cancel switch to stop the a larm buzze Note that the alarm b uzzer does not stop when the starting switch is turned to the OFF position. of 0.5 tons from the 3.5 ton s loaded in the bucket. er the lift arm and then rais e it again in order t o weigh the amount re mainin g in the bu cket. The g in the bucket is weighed and displa yed.