PRECAUTIONS TO BE TAKEN WHEN WORKING 2.4.11 PREVENTING DAMAGE CAUSED BY THE WORK EQUIPMENT When working in tunnels, galleries, under electric cables or other ducts (air, telephone lines) and wherever the height is limited, proceed with the greatest care to prevent the bucket or the arms from causing any damage. 2.4.12 WORKING ON LOOSE GROUND Avoid operating the machine too close to the edge of cliffs, overhangs and deep ditches. These areas may collapse, making the machine fall down or tip over and this could result in serious injuries or death. Remember that after heavy rain or earthquakes these dangerous conditions usually get worse.
The earth laid near ditches is loose and can easily collapse due to the weight or vibrations of the machine. Be extremely careful: always fasten the safety belt and close the cab door, if provided. In case of work in areas where stones or other material may fall on the machine, install the FOPS protection de- vice. 2.4.13 PARKING THE MACHINE Park the machine on firm and level ground. If this is not possible and it is necessary to park on a slope, position the machine with the bucket directed downwards and carry out the following op- erations: 1 - Rotate the bucket to the dumping position and lower the arms until thrusting the teeth into the ground. 2 - Stop the engine.
3 - Put wedges or safety blocks under the tracks. Always rest the work equipment on the ground; if it is necessary to park with raised arms, make sure that the safety locks are en- gaged. CABIN Lock the equipment control by shifting the safety device lever to the lock position. When leaving the machine, remove the ignition key. If it is necessary to park on public roads, provide for signalling the presence of the machine according to the local regulations in force (signalling fires, fences, road works ahead, alternated direction and direction signs, etc.). CANOPY 40