27. USING SEAT BELT When operating a machine equipped with ROPS, be sure to use the seat belt. ¤ WARNING Before fastening the seat belt, inspect the securing brackets and belt for abnormal conditions. Replace any worn or damaged seat belt or the securing brackets. Adjust and fasten the seat belt before operating the machine. Always use seat belt when operating the machine. Fit the seat belt across your lap without twisting. 27.1 FASTEN THE BELT AND REMOVE IT IN THE FOLLOWING MANNER HANDLING SEAT BELT ¤ WARNING Before fitting the seat belt, check that there is no abnormality in the belt mount bracket or mounting belt. If it is worn or damaged, replace the seat belt.
Even if no abnormality can be seen in the belt, replace the seat belt every 3 years. The date of manufacture of the belt is shown on the back of the belt. Adjust the seat belt and fit it before starting operation. Always wear the seat belt during operation. Fit the seat belt so that it fits across your abdomen and is not twisted. 1. Adjust the seat so that the brake pedal can be depressed all the way with the operator’s back against the backrest. 2. After positioning the seat, adjust the tether belt 1 . With the seat unoccupied, tense the belt slightly across the seat and install. 3.
Sit in the seat, hold tongue 4 of reel 2 , and pull the belt out slowly to a length which fully covers your lap. 4. Insert tongue 4 into buckle 3 and push until there is a click. Pull back reel 2 until the belt fits securely across your lap. In this condition, the lock is applied to prevent the belt from extending any further. Fit the seat belt across your lap without twisting. 5-3