MAINTENANCE NORMAL CHARGING Make sure power circuit voltage is the same as that shown on the charger specification plate, Connect charger to pow- er source. The first charge should be for 12 hours before use. Insert battery pack into charger. The red light should glow indicat- ing the battery is charging. After the red light goes out indi- cating a fully charged battery pack the green trickle charge light should glow indicating that the charger has switched to trickle charge mode. The battery pack may be left on the trickle charge until you are ready to use. Disconnect charger from power source when not in use.
INSTALLING OR REMOVING BATTERY PACK TO REMOVE BATTERY PACK Depress the two battery release buttons (one button on each side of battery pack) and pull battery pack out of elec- tric grease gun. TO INSTALL BATTERY PACK Align battery pack with opening in electric grease gun han- dle and push battery pack into handle until it locks in place. POWER Insert the plug in the cigarette lighter socket of 12V or 24V outputs in the power supply of BATTERY CHARGER. 7-24