11. EXPLANATION OF COMPONENTS 2. FUEL CONTROL DIAL (WITH AUTO-DECELERATION MECHANISM) This adjusts the engine speed and output. 1 Low idling (MIN): Turned fully to the left 2 Full speed (MAX): Turned fully to the right MAX MIN 3. CIGARETTE LIGHTER This is used to light cigarettes. To use, push the lighter in. After a few seconds it will spring back. Pull out the lighter and light your cigarette. By removing the cigarette lighter, the socket is available as a power source for the yellow flashing lamp. Max. current is 3.5 A (85 W). AM089400 AM089410 4.
SWING LOCK SWITCH ¤ WARNING When the machine is traveling under its own power, or when the swing is not being operated, always set the switch to the ON (ACTUATED) position. On a slope, the work equipment may swing to the down side even if the swing lock switch is located at the ON position. Be careful concerning this point. This switch is used to lock the upper structure so that it cannot swing. ON position (actuated): The swing lock is always applied, and the upper structure will not swing even if the swing is operated. In this condition, the swing lock lamp lights up. OFF position (canceled):
The swing lock is applied only when all work equipment control levers are at neutral; when any work equipment control lever is operated, it is canceled. The swing lock is actuated approx. 4 seconds after all work equip- ment control lever is placed in neutral. OFF ON AM089420 5. WIPER SWITCH This actuates the wiper for the front glass. 1 OFF: Wiper stops 2 ON: Wiper moves continuously 3 Window washer fluid is sprayed out. When switch is released it returns to position 2 . 4 ON: Wiper moves intermittently 5 Window washer fluid is sprayed out. When switch is released it returns to position 4 . AM089430 2-16