Safety - Section 2 OM2017.2 Page 2-24 Warnings and Cautions A steering procedure for a disabled truck is located on the left frame rail near the unloader valve. This decal provides the operator or technician with the proper hookup procedure for steering on a disabled truck. Quick disconnects are located at the bottom of the bleeddown manifold. A WARNING decal is located on the left top corner of the operator’s cab. This decal states that the cab assembly must not be lifted by using the handrail. High Voltage DANGER plates and CAUTION plates are attached to both doors of the Electrical Control Cabinet.
The High Voltage Plate is also attached to the blown grid housing, extended range housing, rectifier housing, inlet duct structure and rear hatch cover. A wheel motor oil level decal is attached to the gear cover on both electric wheel motors. This decal stresses the fact that the truck must be on a level surface and parked for 20 minutes prior to checking the oil level. This is necessary in order to get an accurate reading.