MAINTENANCE Tire Pressure ELECTRICAL AND IGNITION SYSTEM Battery Maintenance Keep battery terminals and connections free of corrosion. If cleaning is necessary, remove the corrosion with a stiff wire brush. Wash with a solution of one tablespoon baking soda and one cup water. Rinse well with tap water and dry off with clean shop towels. Coat the terminals with dielectric grease or petroleum jelly. 2 Tire Inspection WARNING WARNING Operating an ATV with worn tires will increase the possibility of the vehicle skidding and possible loss of control. Battery electrolyte is poisonous. It contains sulfuric acid. Serious burns can result from contact with skin, eyes or clothing. Antidote:
Worn tires can cause an accident. External: Flush with water. Always replace tires when the tread depth measures 1/8” (.3 cm) or less. Internal: Drink large quantities of water or milk. Follow with milk of magnesia, beaten egg, or vegetable oil. Call physician immediately. CAUTION Maintain proper tire pressure. Refer to the warning tire pressure decal applied to the vehicle. Improper tire inflation may affect ATV maneuverability. When replacing a tire always use original equipment size and type. The use of non-standard size or type tires may affect ATV handling. Eyes: Flush with water for 15 minutes and get prompt medical attention. Batteries produce explosive gases.
Keep sparks, flame, cigarettes, etc. away. Ventilate when charging or using in an enclosed space. Always shield eyes when working near batteries. KEEP OUT OF REACH OF CHILDREN. NOTE: Absorbed Glass Mat (AGM) batteries are permanently sealed at the time of manufacture. AGM batteries are designed to minimize gassing and water loss, but can vent if overcharged. Tire Tread Depth Always replace tires when tread depth is worn to 1/8” (3 mm) or less. IMPORTANT: Never attempt to open the battery. If the seal is broken, the battery will be ruined and will fail within a few weeks. NOTE: If battery voltage is below 12.6V, fully charge the battery before putting into service.
Charge for 3- 5 hours at a voltage not to exceed 14.6V or 10 Amps. Voltage should reach at least 14.4V before end of charge. 2.25 Tire Pressure Inspection (PSI - Cold) Front Rear 7 psi (48 kPa) 5 psi (34.5 kPa) Tread Depth 1/8” (3 mm)