• Install adapter, BMW No. 34 1 536 , instead of the outboard brake pad. • Install resetting tool, BMW No. 34 1 531 , with the handle toward the outside in the rear brake caliper, press the pistons fully back and secure them in this position. • Wrap a cloth around the brake caliper. – [Bleeding only] Bleed the rear wheel circuit. ( a 00.47) • Draw off the old brake fluid from the wheel-circuit reservoir. 1 • • • • e when the cap has been removed from the wheel-cir- cuit reservoir. • Screw container, BMW No. 34 1 581 , onto rear wheel circuit reservoir. • Slowly fill container, BMW No. 34 1 581 , with new brake fluid until it is approximately 1/3 full.
• Connect the brake bleeding device to the bleed screw, but do not switch on the device. L Note: If necessary, use a cable tie to secure the bleed hose to the bleed screw. 00.44 34 00 080 Bleeding/changing brake fluid in rear wheel circuit e Attention: Integral brakes, the front brake must be ready for use. 34 1 536 • Remove fuel tank. e Attention: Do not allow brake fluid to come into contact with painted parts of the motorcycle as brake fluid de- stroys paint. 34 1 531 R28000170 34 1 581 Attention: l piston resetting tool, BMW No. 34 1 531 only R22000350 R22000350