Checking tightness of rear wheel studs Greasing the side stand pivot (Inspection I) (Inspections I, II and III) • Tighten the rear wheel studs with a torque wrench. X Tightening torque: Securing screws for rear wheel .................. 105 Nm Checking rear wheel bearing play by tilting wheel (Inspection III) • Tilt the rear wheel to and fro across its axle. – If play is detected, fit new shims to rear wheel drive or replace bearings. R22000310 a .................................................... see Group 33 • Check free movement of side stand and grease if necessary. • Grease pivot point (arrow). Checking swinging arm bearings, adjusting if necessary Lubricant:
................................................... Shell Retinax EP2 (Inspections I and III) Checking function of side stand contact switch • Grip rear tyre and try to move it sideways, brac- ing against the frame. – If play is perceptible, remove fixed-bearing stud and floating-bearing stud of the bearing in ques- tion, clean the threads and reinstall. (Inspections I, II, III and IV) a .................................................... see Group 33 • Place the motorcycle on its centre stand. • Retract the side stand, if extended. • Disengage the clutch and select a gear. • Start the engine, without releasing the clutch le- ver. • Extend the side stand. L Note:
The side-stand switch is in correct working order if the engine stops when the side stand is extended. 00.53