System Error Codes Boot-Up Error: FPGA (Main PCA) ( 0020 ) Problem Description: The read/write of the FPGA-ATG (Band Memory) and FPGA-RSM (Mask Memory) registers on the Main PCA was diagnosed and an error was detected. Corrective Action: Try the following: „ Replace the Main PCA ⇒ Page 8-35 . Boot-Up Error: FPGA (Carriage PCA) ( 0040 ) Problem Description: The read/write of the FPGA-PTC (Print Timing Controller) and FPGA-PDD (Print Data Distributor) registers on the Carriage PCA was diagnosed and an error was detected. Corrective Action: Try the following: „ Replace the Carriage PCA ⇒ Page 8-91 . „ Make sure that the Carriage Cable is correctly connected. „ Replace the Main PCA ⇒ Page 8-35 .
Boot-Up Error: ASIC CONF (Main PCA) ( 0080 ) Problem Description: The program load from the Flash ROM on the Main PCA to the FPGA on the Main PCA or sum-check was not performed correctly and an error occurred. Corrective Action: Try the following: „ Reload the ASIC program from the IC Card. „ Replace the Main PCA ⇒ Page 8-35 . Boot-Up Error: ASIC CONF (Carriage PCA) ( 0100 ) Problem Description: The program load from the Flash ROM on the Main PCA to the ASIC on the Carriage PCA or sum-check was not performed correctly and an error occurred. Corrective Action: Try the following: „ Reload the ASIC program from the IC Card. „ Make sure that the Carriage Cable is correctly connected.
„ Replace the Carriage PCA ⇒ Page 8-91 . „ Replace the Main PCA ⇒ Page 8-35 . Problem Description: The read/write of the image band memory on the Main PCA was diagnosed and an error was detected Boot-Up Error: DRAM ( 0200 ) Corrective Action: Try the following: „ Replace the Main PCA ⇒ Page 8-35 . HP Designjet 9000s Series Printer Service Manual 2-5