Preventing material damage en 2 Preventing material 3.2 Saving energy damage If you follow these instructions, your appliance will use less power. ATTENTION! If not rolling freely, the appliance's castors may damage the floor when the appliance is moved. ▶ Transport the appliance using a Selecting the installation location Ў Keep the appliance out of direct sunlight. Ў Install the appliance as far away as possible from heating elements, cookers and other heat sources: – Maintain a 30 mm clearance to sack truck. ▶ Use floor protection when moving the appliance, and do not move it in a zigzag fashion.
Using the base, runners or appliance doors as a seat surface or climbing surface may damage the appliance. ▶ Do not stand or support yourself electric or gas cookers. – Maintain a 300 mm clearance to oil or solid-fuel cookers. Ў Make sure there is a small gap between the side wall and the ap- pliance. Ў Never cover or block the external on the base, runners or doors. Contamination with oil or fat may cause plastic parts and door seals to become porous. ▶ Keep plastic parts and door seals Saving energy during use Note: The arrangement of the fittings does not affect the energy consump- tion of the appliance. Ў Open the appliance only briefly ventilation openings. free of oil and grease.
Metal or metal-style parts in the appli- ance may contain aluminium. Alu- minium reacts when it comes into contact with acidic foods. ▶ Do not store unpackaged food in and then close it carefully. Ў Never cover or block the interior the appliance. ventilation openings or the exterior ventilation openings. Ў Transport purchased food in a 3 Environmental protec- cool bag and place in the appli- ance quickly. Ў Allow warm food and drinks to tion and saving energy cool down before storing them. Ў Thaw frozen food in the refrigerator 3.1 Disposing of packaging compartment to utilise the low tem- perature of the food.
Ў Always leave some space between The packaging materials are environ- mentally compatible and can be re- cycled. ▶ Sort the individual components by the food and to the back panel. Standby mode If the appliance is not being used, the display automatically switches to standby mode. In standby mode, the brightness of the control panel is reduced and the status display lights up white. type and dispose of them separ- ately. 15